TM 5-3740-218-13&P
4-19. ENGINE AND PUMP ASSEMBLY REPLACEMENT (CONT)
C.
INSTALLATION
WARNING
Gasoline is flammable. Do not work on fuel system in presence of sparks and
open flame. Serious personal injury could result if fuel ignites.
Engine is heavy and cumbersome.
Use two persons when lifting or moving
engine to prevent personal injury.
(1)
Using two persons, lift engine assembly (1). Align engine with isolators (2) and place engine assembly (1)
on isolators (2).
(2)
Install four washers (3) on four bolts (4). Install four bolts (4) through bottom side of isolators (2) through
engine mount holes. Install four washers (3) and four nuts (5) to secure engine. Torque nuts to 25 lb-ft (34
N.m).
(3)
Remove caps and connect inlet (6) and outlet (7) hydraulic hoses to hydraulic pump (8).
(4)
Connect four ground wires (9) to rear of engine case ground stud (10).
(5)
Connect six banana clip wires (11) to bucket harness.
(6)
Connect starter solenoid electrical leads (12) to starter solenoid.
(7)
Connect throttle cable (13) to carburetor (14).
(8)
Secure throttle cable (13) to engine (1) with adel clamp (15), washer (16), and bolt (17).
(9)
Connect fuel line (18) to carburetor (14).
(10)
Secure fuel line (18) with adel clamp (19), bolt (20), washer (21), and nut (22).
(11)
Turn fuel strainer petcock (23) to ON position.
(12)
Connect spark plug wire (24).
(13)
Fill hydraulic reservoir (para 4-34).
4-32
