TM 5-3740-214-14
COMPRESSOR MAINTENANCE (Continued)
Figure 5-264. Separator Nozzle Connection
(4) Attach nozzle assembly to separator assembly.
(a) Attach adjusting nut, nipple, O-ring, and swivel elbow to street elbow.
(b) Attach O-ring, adjusting nut, nipple, and nozzle body to swivel elbow.
(c) Attach nipple and solenoid valve to nozzle body.
CAUTION
DO NOT use too much force to tighten fluid nozzle. Tighten it by hand. Too much force will
damage the Teflon gasket.
DO NOT use tools to tighten knurled ring; tighten by hand.
(d) Assemble fluid nozzle, teflon gasket, air cap and knurled ring and attach them to nozzle body.
(5) Install compressor assembly.
(a) Line up compressor and mounting holes.
(b) Insert tensioner studs and bolt plate studs through mounting holes.
(c) Thread tensioner screw into belt tensioner.
(d) Tighten mounting nuts.
NOTE
An alignment gage can be made from a piece of scrap metal or wood and be used to line up the
(6) Adjust belt tension and pulley alignment. See belt maintenance on page 4-12 for details.
(7) Install air hose between pulsation tank and inlet side of air pressure regulator.
5-239
