TM 5-3740-214-14
ELECTRICAL PARTS GROUP (Continued)
Figure 5-244. Starter Assembly
d. Assemble electrical parts group.
(1)
Assemble starter.
(a) Insert stud terminal brush into end cap. Tighten nuts and bushings. Use the old bushings.
(b) Insert input brushes into rear end cap. Use new springs. Be sure the angled edge of the brushes is away
from the springs.
(c) Set rear end cap and brushes in place on starter body.
(d) Insert armature into starter body. Insert rear end of shaft into rear end cap.
(e) Slide front end cap over armature shaft and tighten end caps.
(f) Attach thrust washer and pinion gear to armature shaft.
(g) Attach spacer, spring and dust cover.
(h) Secure parts to shaft with retaining nut and washer.
5-223
