TM 5-3740-214-14
Table 5-3. Direct and General Support Maintenance Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE KNOCKS (Continued)
Figure 5-169. Gapping Breaker Points
(2)
Loosen the point gap adjustment screw and place an 0.020 inch (0.52 mm) feeler gage between
the points.
(3)
Tighten the adjusting screw after setting the gap.
(4)
Replace the breaker point cover and go to Step 2e.
e.
Start the engine.
(1)
If the engine starts, the problem is solved.
(2)
If the engine does not start, go to Step 3.
Step 3.
Check the engine compression.
NOTE
Because automatic compression release engines release compression at
600 rpm, there is a different compression test procedure for this engine.
a.
Start the engine and run it for fifteen minutes.
b.
Shut the engine OFF and remove the spark plug.
5-154
