TM 5-3655-214-13&P
5-3. MOTOR, ELECTRIC (MODEL - 12681-2) - Continued
CLEANING, INSPECTION
1.
a
Clean end bells (17, 21) in an approved
cleaning solvent, and dry with a clean
cloth or compressed air.
b. Clean electrical parts with a clean soft
bristled brush or blow with compressed
air.
c.
Inspect end bells (17, 21) for cracks or
other defects.
d. Inspect bearings (9) for looseness, flat
edges, or other defects.
e. Inspect electrical parts for evidence of
overheating, arcing or insulation break-
down.
REPAIR
2.
a
Replace all defective parts.
REASSEMBLY
3.
a
Install grommet (27, 26) in stator and
housing (28).
b. Reassemble three grommets (24) and
three plugs (23), rotating switch (22)
and install rotor (25) in stator and hous-
ing (28).
c.
Install one bearing (18) on each end of
rotor shaft.
d. Install two switches (20) with four
screws (19) in end bells (21).
5-8