Hexagon head cap
Unscrew and remove two hexagon head cap screws (11), flat
washers (12), shock mount pads (13), and one machine bolt (14).
screws (11)
Flat washer (12)
Remove moveable part of channel assembly (15).
Shock mount pad (13)
Machine bolt (14)
Do not remove the two sets of nuts (channel clamping style) (16) or the
Channel assembly (15)
Nut (16)
stationary part of channel assembly (15) unless replacement is required.
Pump Base Skid, Engine
Replace authorized unserviceable parts.
Mount 1, Engine Mount 2/
Use chassis and running gear brush, wiping rags, scratch wire brushes,
abrasive cloth, and dry cleaning solvent to remove paint, grease, and
grime from the pump base skid and around each of the stationary parts of
the channel assemblies. Any cracked or broken welds will be rewelded
(see TM 9-237).
When welding or rewelding the stationary channel assemblies, they will
be located as illustrated.
CAUTION
Altering the mounting will cause misalinement between engine, pump,
and alternator drive pulleys.
Use polyurethane paint and paint brush to touch up unpainted surfaces.
2-121
TM 3-4230-209-30&P
