TM 3-4230-209-30&P
2-26
2-10. COVER PANEL ASSEMBLY (CONT).
REMARKS
LOCATION/lTEM
ACTION
Cover Panel Assembly/
Replace authorized unserviceable parts. When gaskets are loose but not
Gaskets
brittle or damaged, rebond to access cover with adhesive. Fabricate gas-
Repair access cover by straightening dents, removing rust, and repainting
Access cover
lettering with black polyurethane coating and small paint brush. Use
green polyurethane coating to paint the panel. Refer to TM 43-0139.
Repaint REMOVE BEFORE OPERATING in 1 1/2 inch high letters with
black polyurethane coating.
Cover PaneI Assembly/
Bond gaskets (1) to back side of access cover (2) with adhesive. Cut
Gaskets (1)
holes in gasket (1) at assembly to fit.
Access cover (2)
Bond gaskets (3) to back side of access cover (2) with adhesive. Cut
Gaskets (3)
holes in gaskets (3) at assembly to fit. After fitted properly trim gasket in
the notch area to clear notch.
Turnlock stud
Use camloc fastener tool and camloc fastener pliers to replace turnlock
stud assemblies (4), turnlock fastener eyelets (5), and retaining rings (6).
assemblies (4)
Turnlock fastener
eyelets (5)
Retaining rings (6)
