TM 10-8415-210-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Subject
Page
Section I
OPERATOR MAINTENANCE PROCEDURES .............................................................
3-1
3-1
INSPECTION ...............................................................................................................
3-1
3-2
CLEANING ..................................................................................................................
3-1
Section I. OPERATOR MAINTENANCE PROCEDURES
3-1. INSPECTION. Perform inspection as described in Chapter 2, Section II, PMCS. Report defects on DA Form 2404.
3-2. CLEANING. Clean all TAP Ensemble components that have been worn in a suspect environment and not subject
to liquid or vapor contamination by flushing fully with fresh water. Air-dry the components for a minimum of 12 hours
prior to next use, hanging components by suspension straps only or placing boots and gloves on pallets a minimum of 6
inches off the floor.
3-1/(3-2 blank)