TM 10-8415-208-12
d. Loosen clamp (6) and remove communication piece (5) and clamp (6) from face piece (2).
e. Immerse breathing tube (4) and face piece (2) in hot soapy water.
f. Scrub gently until clean.
g. Rinse breathing tube (4) and face piece (2) in clean water.
h. Sanitize breathing tube (4) and face piece (2) in sanitizing solution.
i. Rinse breathing tube (4) and face piece (2) in clean warm water and allow them to air dry.
j. When dry, remove the plastic bag and tape from electrical connector (3) and warning light (1).
k. Install warning light (1) to face piece (2) using the screws removed in step a.
I. Install communication piece (5) using clamp (6) and attach breathing tube (4).
3-10. REBREATHER SYSTEM MAINTENANCE INSTRUCTIONS.
This task covers:
a.
Inspection
c.
Replacement
e.
Testing
b.
Service
d.
Cleaning
INITIAL SETUP
Tools
Hose Coupler (Appendix B, Section III, item 16)
Leak Test Fixture (Appendix B, Section III, item 18)
Technical Manual (Appendix B, Section III, item 20)
Pliers (Appendix B, Section III, item 23)
Pliers (Appendix B,. Section Ill, item 24)
Pressure Test Knob (Appendix B, Section III, item 29)
Relief Valve Tool (Appendix B, Section III, item 31)
Screwdriver (Appendix B, Section III, item 32)
Screwdriver (Appendix B, Section III, item 33)
Screwdriver (Appendix B, Section III, item 34)
Valve Core Extractor (Appendix B, Section III, item 36)
Wrench (Appendix B, Section III, item 38)
Wrench (Appendix B, Section III, item 39)
Wrench (Appendix B, Section III, item 40)
Wrench (Appendix B, Section III, item 41)
Wrench (Appendix B, Section III, item 42)
Wrench (Appendix B, Section III, item 43)
Wrench (Appendix B, Section III, item 44)
Wrench (Appendix B, Section III, item 45)
Wrench (Appendix B, Section III, item 46)
Wrench (Appendix B, Section III, item 47)
Wrench, Torque (Appendix B, Section III, item 48)
Ruler (Appendix D, Section II, item 23)
3-81