TM 10-8415-208-12
(3)
Thread the end of waist strap (16) through the openings on both sides of support assembly (5).
(4)
Work all but about one foot of waist strap (16) through support assembly (5).
(5)
Thread waist strap (16) into buckle (17) and attach belt loop (18).
(6)
Carefully snap the plastic top back onto buckle (17).
(7)
Position back pad (15) on waist strap (16) with the snaps toward support assembly (5).
(8)
Attach back pad (15) to waist strap (16) by snapping retaining straps (14) around waist strap (16).
(9)
Adjust/tighten waist strap (16).
(10) Install cylinder bumpers (13) to support assembly (5) using screws (12).
(11)
Install filter housing (11) with bracket using bolts (10), washers (9) and nuts (8).
(12) Connect air line coupling (6) to male connector (7).
(13) Route vent tubes around support assembly (5).
(14) Install regulator bracket (4) using bolts (3), washers (2) and nuts (1).
(15) Perform steps b.(4) through b.(6), paragraph 3-9.2.6, to install the regulator.
(16) Perform steps b.(1) through b.(7), paragraph 3-9.2.5, to install the battery box and electrical lines.
(17) Perform steps b.(1) through b.(5), paragraph 3-9.2.3, to install the cylinder.
(18) Leak test the EBA and perform the Static Pressure Test and the Air Flow Performance Test. Refer to
paragraphs 3-9.3.1 through 3-9.3.3.
(19) Perform steps b.(1) through b.(4), paragraph 3-9.2.4, to install the cushion cover.
3-55
