TM 10-5410-228-24
(10) Remove PVC hose (13) by loosening hose clamp (14) on other end of PVC hose (13) and sliding
PVC hose (13) off its connection.
(11) Remove two cushion clamps (15) on aluminum tubing tee (16) and remove aluminum tubing tee
(16).
(12) Remove four screws (17), four lockwashers (18) and four flat washers (19) securing hydraulic
overflow container (1) to front, lower, driver side corner casting of LMS. Discard four
lockwashers (18).
b. Installation (Refer to Figure 3-27)
(1)
Secure hydraulic overflow container (1) to front, lower, driver side corner casting of LMS with
four screws (17), four new lockwashers (18) (Item 20, Appx E) and four flat washers (19).
(2)
Install ball valve (2) in hydraulic overflow container (1).
(3)
Install hose barb (4) in ball valve (2).
(4)
Connect PVC hose (3) on hose barb (4) with hose clamp (5).
(5)
Connect PVC hose (13) to drain port under passenger side of ECU with hose clamp (14).
(6)
Connect PVC hose (11) to drain port under driver side of ECU with hose clamp (12).
(7)
Connect aluminum tubing tee (16) to PVC hose (11) and (13) with hose clamps (12 and 14) on
either end.
(8)
Install two cushion clamps (15) on aluminum tubing tee (16).
(9)
Connect PVC hose (8) between the aluminum tubing tee (16) and hydraulic overflow container
(1) with hose clamps (10) on both ends and a strap (9).
(10) Connect PVC hose (6) to hydraulic overflow container (1) with hose clamp (7).
a. Removal (Refer to Figure 3-27)
NOTE
ECU front door must be opened to gain access to PVC tubing.
(1)
Remove PVC hose (20) from drip pan inside, front, driver side of ECU by loosening two hose
clamps (21) on both ends of PVC hose (20) and sliding PVC hose (20) off its connections.
(2)
Remove two cushion clamps (22) on PVC hose (23).
(3)
Remove PVC hose (23) from drain port, under, front, driver side of ECU by loosening hose clamp
(24) and sliding PVC hose (23) off the drain port.
(4)
Remove cushion clamp (25) on PVC hose (26) and (27).
NOTE
ECU front cover must be opened, and ECU passenger side access cover, prefilter cover, and
mist eliminator must be removed to gain access to PVC hose.
(5)
Remove PVC hose (26) from drip pan inside front passenger side of ECU by loosening hose
clamp (28) and sliding PVC hose (26) off its connection.
(6)
Remove drain tubing (29) from PVC hose (26) by loosening hose clamp (30) and sliding drain
tubing (29) off PVC hose (26).
NOTE
ECU mist eliminator must be removed to gain access to PVC hose.
(7)
Remove PVC hose (27) from drain port inside rear passenger side of ECU by loosening hose
clamp (31) and sliding PVC hose (27) off drain port.
