TM 10-5410-228-24
(32) Install new O-ring (8) (Item 51, Appx E) on tee (7). Ensure O-ring (8) is seated and retained
properly.
(33) Lubricate O-ring (8) with a light coating of hydraulic fluid.
(34) Install tube assembly (6) on tee (7) on oil cooler (4), finger tight. Adjust position of tube
assembly (6) and tee (7) as required.
(35) Torque tee (7) on oil cooler (4) to 1,080 45 in.-lb (90 5 ft-lb).
(36) Torque tube assembly (6) on tee (7) to 1,080 45 in.-lb (90 5 ft-lb).
(37) Torque reducer (10) on tee (7) to 1,080 45 in.-lb (90 5 ft-lb).
(38) Torque tube assembly nut (9) on reducer (10) to 480 25 in.-lb (40 2 ft-lb).
(39) Remove plug from end on tube assembly (2). Check tube assembly (2) sealing surfaces for
damage or material build up. Clean any material build up with clean, lint-free cloth. If required,
replace tube assembly (2) per para 3.9.11.
(40) Install new O-ring (5) (Item 51, Appx E) on union (3). Ensure O-ring (5) is seated and retained
properly.
(41) Lubricate O-ring (5) with a light coating of hydraulic fluid.
(42) Install tube assembly (2) on union (3) on oil cooler (4), finger tight.
(43) Torque tube assembly (2) on union (3) to 1,080 45 in.-lb (90 5 ft-lb).
(44) Install compressor discharge and suction port caps (1).
3-113
