TM 10-5410-228-24
(15) Secure receptacle connector (110) to mounting pan (1) with four screws (109), four flat washers
(108), four new lockwashers (107) (Item 14, Appx E) and four nuts (106).
(16) Install wires on two sockets (105) and install two sockets (105) on relay mount bracket (89).
Remove tags from wires.
(17) Install and tighten four nuts (102) on four captive screws (103) to secure two relays (104) to two
sockets (105).
(18) Install wires on socket (101) and install socket (101) on relay mount bracket (89). Remove tags
from wires.
(19) Install and tighten two nuts (98) on two captive screws (99) to secure relay (100) to socket (101).
(20) Install wires on two sockets (97) and install two sockets (97) on relay mount bracket (89).
Remove tags from wires.
(21) Install and tighten six nuts (94) on six captive screws (95) to secure two relays (96) to two
sockets (97).
(22) Install wires on six sockets (93) and install six sockets (93) on relay mount bracket (89). Remove
tags from wires.
(23) Install and tighten twelve nuts (90) on twelve captive screws (91) to secure six relays (92) to six
sockets (93).
(24) Secure retainer bracket (88) on relay mount bracket (89) with six captive screws (87).
NOTE
Apply sealant to screws (86) only where the threads intersect mounting pan (1) to keep nuts
(85) from coming loose.
(25) Secure two screws (86) to mounting pan (1) with two nuts (85). Apply a small amount of sealant
to two screws (86).
(26) Secure support enclosure (84) to screws (86) with four flat washers (83), two new lockwashers
(82) (Item 17, Appx E) and two nuts (81).
(27) Secure terminal board assembly (78) to mounting pan (1) with two screws (80) and two nuts
(79).
(28) Secure two terminal lugs (77) to terminal board assembly (78) with flat washer (76), new
lockwasher (75) (Item 20, Appx E) and nut (74). Remove tags from wires.
(29) Secure terminal board TB1 (71) to mounting pan (1) with two screws (73) and two nuts (72).
NOTE
Note polarity on diodes before installing. See Figure 2-46, sheet 5, View C-C.
(30) Install eight diodes (70) on terminal board TB1 (71). Install wires on terminal board TB1 (71).
Remove tags from wires.
(31) Secure terminal board TB2 (67) to mounting pan (1) with two screws (69) and two nuts (68).
NOTE
Note polarity on diodes before installing. See Figure 2-46, sheet 5, View B-B.
(32) Install four diodes (66) on terminal board TB2 (67). Install wires on terminal board TB2 (67).
Remove tags from wires.
(33) Secure neutral and ground bars (61) to mounting pan (1) with two screws (63), two flat washers
(64), two new lockwashers (63) (Item 17, Appx E) and two nuts (62).
(34) Install wires on neutral and ground bars (61). Remove tags from wires.
(35) Apply anti-seize tape to threads of four barbed connectors (59) and install four barbed
connectors (60) on four barbed connectors (59).
2-231
