TM 10-5410-228-24
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV power off.
Repair (Item 38, Appendix B)
ECV battery ground cable disconnected
Drill, Electric (Item 6, Appendix B)
(see TM 9-2320-387-24-1).
Drill Set (Item 5, Appendix B)
ECV parking brake set.
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
Materials/Parts:
Four Blind Rivets (Item 74, Appendix E)
Extraction Tool (Item 10, Appendix B)
Antiseize Compound (Item 13, Appendix C)
References:
TM 9-2320-387-24-1
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
Hydraulic Fluid Level Switches/Indicators.
a. Removal (Refer to Figure 2-12)
NOTE
Steps 1 through 5 apply to both switches.
(1)
Using extraction tool, carefully squeeze tabs (1) and pry indicator unit (2) loose from switch
housing (3).
(2)
Using a small, flat head screwdriver, turn two screws (4) counterclockwise until two retaining
cams (5) lay down.
(3)
Pull switch housing (3) from ECV dash (6) and retainer cover (7).
(4)
Tag and unsolder leads to two switches (8 and 9).
(5)
Remove switch housing (3) and retainer cover (7) from ECV.
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
(6)
Drill out four rivets (10) securing two legend plates (11 and 12) to ECV dash (6).
