TM 5-6350-264-14&P-10NAVELEX EE 181-AA-OMI-110/E121 C-9412T.O. 31S9-2FSS9-1-10Table 5-2. Troubleshooting Procedures - ContinuedTroubleProbable causeCorrective action4.(Cont)c.Bad tampera.Set multimeter to dc volts and connectcircuitrypositive meter lead to PC board A7-TP2(telephone(red), and negative lead to chassisdialer).(ground).b.If meter indicates 18.5 to 21 vdc, ensurethat there is a jumper between TB7,S-8 and S-9. Set multimeter to ohmsand connect leads to TB7, S- andS-9. If meter indicates more than0 ohms, replace jumper.c.If meter indicates 0 ohms, turn off switchS1 on power supply. Use board ejectorto remove PC board A7. Connectmeter leads to J7-1 and J7-7.d.If meter indicates more than 100, 000 ohms,inspect J12/P1, pins 19 and 34 forbroken or loose wires. Resolder anybad connections at P1, pins 19 and 34.e.If meter indicates 0 ohms at J7-1 and J7-7,replace PC board A7.To install new PC board, turnboard so plastic ejector istoward top. Align board withguides at top and bottom ofstatus processor. Slide boardstraight in until it contacts re-ceptacle at back of processor.Then press firmly on boarduntil it seats completely inreceptacle.f.Turn on switch S1 on power supply. De-press TRANSMITTER RESYNCswitch S2. Wait about 5 minutes forsystem to stabilize. During 5-minutestabilization period, check ower sup-ply. Set multimeter to dc voltsand connect negative lead to chassis(ground). Connect positive lead topower supply, TB2-3. Meter shouldindicate 20 +1 vdc. Connect positivelead to TB2-S. Meter should indicate5-56
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business