TM 5-6350-264-14&P-10NAVELEX EE 181-AA-OMI-110/E121 C-9412T.O. 31S9-2FSS9-1-10Table 5-2. Troubleshooting Procedures - ContinuedTroubleProbable causeCorrective action1.(Cont)f.(Cont)switch mounting bracket to insideof CU door. Remove switch andmounting bracket together. Becareful not to lose switch arm be-cause it is not secured to switchshaft. Remove spacer and lockfrom door so no items will be lost.Remove small hex nut and lockwasher that secures mounting brac-ket and switch stop to switch shaft.Remove mounting bracket andswitch stop. Note that modeswitch is a three deck switch. Tagwires and use a soldering iron of50 watts maximum to remove themfrom switch terminals.(2) To install new mode switch, use asoldering iron of 50 watts maxi-mum to connect wires to switchterminals. Slip mounting bracketand switch stop over switch shaft.Ensure that notch in mountingbracket fits over tab on switchbody, and that the tang on switchstop engages notch in mountingbracket. Secure bracket and stopto switch with lock washer andsmall hex nut. Insert lock throughhole in CU door; slip spacer overlock. Slip switch arm over switchshaft. Ensure that arm is alignedwith tang on switch stop. Placelarge hex nut inside switch mount-ing bracket; slip bracket over lock.Engage switch shaft in lock. Tight-en nut to secure switch.(3) Turn on switch S1 on power sup-ply. Depress TRANSMITTERRESYNC switch S2. Wait about5 minutes for system to stabilize.During 5-minute stabilization per-iod, check power supply. Setmultimeter to dc volts and connectnegative lead to chassis (ground).Connect positive lead to power5-30
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business