TM 5-3740-218-13&P
(5)
Remove and cap 1/2-in. hydraulic hose (8) from front, bottom quick-disconnect fitting (9) on primary hydraulic
manifold (10).
(6)
Remove and cap 3/4-in. hose (11) from quick-disconnect fitting on back of hydraulic filter (12).
NOTE
Two people are required to remove motor and slinger assembly.
(7)
Remove motor and slinger assembly (13) from engine platform (14) by removing four nuts (15), eight washers (16),
and four bolts (17).
(8)
Using appropriate clamping device, clamp to both left and right hopper assemblies (18).
(9)
Remove six nuts (19), six washers (20) six bolts (21), six washers (20), and six clips (22) from each hopper
assembly.
(10) While supporting hoppers, remove clamping device. Carefully lower and remove hopper assemblies.
2-53
