TM 5-3740-218-13&P3Set primary manifold pressure at 1200 psi.4Set both meters to same setting.WARNINGPersonnel handling solid or liquid pesticides shall use appropriate personal protectiveequipment consisting of respirators, coveralls, rubber gloves, goggles, etc., as requiredby type of pesticide used and in accordance with manufacturer's label directions. Avoiddirect contact with pesticide. Observe all warnings on label. Handle pesticide in well-ventilated area. Failure to do so could result in personal injury.5Fill left and right hopper assemblies with pesticide.6Open left and right hopper assemblies for 1 minute and record weight of material in each container. (Be sureto subtract weight of container itself.) Repeat.7Change both meter settings to same setting.8Repeat steps 6 and 7 for each meter setting, then determine average flow rate (lb/min) for both hopperassemblies.9Repeat step 6 if one of the four weights for meter setting is significantly different from others.(b)Swath "Width. If new pesticide is being used, or flight altitude is to be over 50 ft, it is advisable to determine actualswath width. Perform the following:WARNINGPersonnel handling solid or liquid pesticides shall use appropriate personal protectiveequipment consisting of respirators, coveralls, rubber gloves, goggles, etc., as requiredby type of pesticide used and in accordance with manufacturer's label directions. Avoiddirect contact with pesticide. Observe all warnings on label. Handle pesticide in well-ventilated area. Failure to do so could result in personal injury.1Fully assemble PDU for SD system operation and fill left and right hopper assemblies with desired pesticideor similar material with same density and particle size.2-36
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
