TM 5-3740-218-13&PLV BOOM ASSEMBLY REPLACEMENT/REPAIR (CONT)B.REMOVAL/DISASSEMBLYNOTERepair of the LV boom is limited to replacement of damaged wire ropeassemblies, cushion clamps, quick-release pins, and nozzles.Both LV boom assemblies are removed/disassembled the same way. Thefollowing procedure is for the right-side LV boom assembly.Booms and struts are number and color-coded; right is green and left is red. The"connect points" referred to in this procedure are the places on the boomassembly where struts and booms with like colors and numbers are to be joined.(1)Remove clamps (1, 2, and 3) from boom. Pull back Kamlock ears and remove boom extension (4) atConnect Point 11.(2)Apply upward pressure to outboard boom weldment (5) and remove quick-release pin (6) at Connect Point7.(3)Pull back Kamlock ears and remove outboard boom weldment (5).(4)Remove two quick-release pins (7 and 8) at Connect Points 8 and 9. Remove two struts (9 and 10).(5)Remove quick-release pins (11 and 12) at Connect Points 5 and 6. Remove cross strut (13).(6)Remove quick-release pin (14) at Connect Point 4. Remove two struts (15 and 16).(7)Remove quick-release pin (17) at Connect Point 3.(8)Pull Kamlock ears back and remove outboard boom weldment (18) from center boom weldment (19) ofpump and crosstube assembly.(9)Remove two quick-release pins (20 and 21) at Connect Points 1 and 2. Remove two struts (22 and 23).(10)If damaged, unscrew and remove spray nozzles (24).4-124
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
