TM 5-3740-214-14
Table 5-3. Direct and General Support Maintenance Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE LACKS POWER (Continued)
(1)
Loosen the spark plug a few turns.
(2)
Blow out the spark plug well with high pressure air. This will clean out any dirt or debris that can
fall into the cylinder.
(3)
Remove the spark plug by hand.
Figure 5-144. Installation of Compression Gage
c.
Place a compression gage in the spark plug hole. Make sure it seals well.
d.
Set the choke wide open. Remove the air cleaner if necessary.
e.
Crank the engine by hand counterclockwise (left: opposite to normal rotation).
f.
Take eight to ten compression readings.
(1)
The first few turns of the engine, the compression may be as low as 30 psi. After the seventh
turn, the compression should be 90 psi.
(2)
If the compression is less than 90 psi, replace the engine.
5-132
