TM 5-3740-214-14
Table 5-3. Direct and General Support Maintenance Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE DOES NOT START BUT TURNS OVER (Continued)
(2)
Loosen the point gap adjustment screw and place an 0.020 inch (0. 52 mm) feeler gage between
the points.
(3)
Tighten the adjusting screw after setting the gap.
(4)
Replace the breaker point cover and go to Step 7e.
e. Start the engine.
(1)
If the engine starts, the problem is solved.
(2)
If the engine does not start, go to Step 8.
Figure 5-39. Engine Coil Location
a. Remove the condenser from the engine.
5-34
