TM 5-3740-214-14
Table 2-1. Operator Preventive Maintenance Checks and Services
B - Before
D - During
A - After
INTERVAL
FOR READINESS REPORT-
ITEM
ITEM TO BE INSPECTED.
ING, EQUIPMENT IS NOT
NO.
B
D
A
PROCEDURE
READY/AVAILABLE IF:
1
GENERAL
Figure 2-4. Engine Installation
a. Make sure all component mounting screws, nuts, and
Subassemblies are not
bolts are tightened securely.
tightened securely
b. Make sure all attached engine compressor and
formulation tank parts are securely fastened.
2
ENGINE ASSEMBLY
Check crankcase oil level.
The oil level is slightly above
or below the low (L) mark
a. Remove plug dipstick (figure 2-5).
on the dipstick
b. Wipe off dipstick and return it to crankcase. Do not
screw it back into crankcase.
c. Remove dipstick again and check oil level. The level
must be kept near the full (F) mark on dipstick.
2-4
