TM 3-4730-200-15
APPENDIX IV
ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT
MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
(INCLUDING DEPOT MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS)
Section I. INTRODUCTION
1. Scope
a. Source, Maintenance, and Recoverability Codes
(SMR), (5 Positions).
This appendix lists repair parts required for the
performance of organizational, direct support, general
(1) Source codes (positions 1 and 2).
support, and depot maintenance of the M1 line filling
Indicates the source for the listed items. Applicable
adapter.
source code is:
2. General
Code
Explanation
This Repair Parts and Special Tools List is divided into
PA -------------------Item
procured
and
stocked
for
the following sections:
anticipated or known usage.
a. Repair Parts List-Section II. A list of repair parts
NOTE
authorized at the organizational, direct support, general
support, and depot levels for the performance of
Cannibalization or salvage may be
maintenance. The list also includes parts which must be
used as a source of supply for any
removed for replacement of the authorized parts. Parts
item source coded PA.
are listed in figure and item number sequence.
(2) Maintenance codes (positions 3 and 4).
b. Special Tools List-Section III. Not applicable.
(a) Position 3. The maintenance code
c. Federal Stock Number and Reference Number
entered in the third position indicates the lowest
A list, in ascending numerical
maintenance level authorized to remove, replace, and
sequence, of all Federal stock numbers appearing in the
use the support item.
Capabilities of higher
listings, followed by a list, in alphanumeric sequence, of
maintenance categories are considered equal or better.
all reference numbers appearing in the listings. Federal
Applicable maintenance code is:
stock numbers and reference numbers are cross-
referenced to each illustration figure and item number
Code
Explanation
appearance.
O ---------------------Organizational maintenance
3. Explanation of Columns
c. Description. Indicates the Federal item name
The following provides an explanation of columns found
and a minimum description required to identify the item.
in the tabular listings.
The last line indicates the reference number followed by
the applicable Federal Supply Code for Manufacturer
(FSCM) in parentheses. The FSCM is used as an
element in item identification to designate manufacturer
or distributor or Government agency. etc. and is
identified in SB 708-42.
13