TM 3-4230-209-30&P
2-112
2-23. OFFSET VALVE AND REGULATING VALVE (CONT).
REMARKS
ACTION
LOCATION/lTEM
Offset Valve No. 1/
The offset valve may be disassembled and reassem-
Remove handle (1) by driving out pin (2) and spring pin (3). Slide off shaft
Handle (1)
extension (4) and bevel gear (5). Remove sleeve bearing (6) from mount-
bled without disassembling the plumbing assembly.
Pin (2)
ing bracket (7).
Spring pin (3)
Shaft extension (4)
Bevel gear (5)
Sleeve bearing (6)
Mounting bracket (7)
NOTE
Unscrew and remove eight setscrews (8), bevel gear (9), collar (10), two
Setscrew (8)
Hexagon head cap screws (13) are subcom-
hexagon head cap screws (11), two hexagon plain nuts (12), two
Bevel gear (9)
ponents of the regulating valve. Two are
hexagon head cap screws (13), two hexagon plain nuts (14), and lubrica-
Collar (10)
removed and replaced by hexagon head cap
tion fitting (15).
Hexagon head cap
screws (11) because of the extra length
screws (11)
requirements. If a new regulating valve is
Hexagon plain nuts (12)
received, use the two screws in the valve
Hexagon head cap
being replaced.
screws (13)
Hexagon plain nuts (14)
Lubrication fitting (15)
Handle (1) is a component part of the regulating
Separate mounting bracket (7) and the two halves (16 and 17) of regulat-
Valve halves (16 and 17)
valve (18). The handle is repositioned for the applica-
ing valve (18) to gain access to valve diaphragm (1 9).
Regulating valve (18)
ble offset valve.
Valve diaphragm (19)
