TM 10-8415-210-13&P
2.
Ensure snap fastener reinforcement patches (6) are secure along all edges.
3.
Ensure sleeve tabs (7) are secure, with female portion of snap fastener facing male portion.
4.
Turn outer sleeve inside out and examine strapping to ensure it is attached securely along the edges.
5.
Mark all defects with chalk.
(j)
Inspection of right and left front upper half (outside).
1.
Repeat steps (b) 1 and (b) 2.
2.
Ensure facings are not tight, short, or twisted, resulting in puckering or distortion.
3.
Mark all defects with chalk.
(k)
Inspection of gusset (outside). Repeat steps (b) 1, (b) 2 and (b) 4.
(1)
Inspection of collar (inside and outside).
1.
Ensure collar (8) is not twisted, puckered, or pleated at the joints of front and back panels to collar.
2.
Ensure webbing straps (9) are attached with box stitch.
3.
Ensure reinforcement patches (10) are attached securely.
5-21