REPLACE SNAP FASTENERS

TM-10-8415-210-13P Toxicological Agent Protective (TAP) Ensemble Manual
Page Navigation
48

TM 10-8415-210-13&P 5-11. REPLACE SNAP FASTENERS. This task covers: a. Preparing Material b. Installing Female Section c. Installing Male Section INITIAL SETUP Tools: Snap Setting Tool (Appendix B, Section III, Items 5 and 6) Materials/Parts: Snap Fastener (Appendix C-1, Item 2; C-2, Item 2 and 5) NOTE Snap fastener replacement procedures are for use when snap fastener has failed, but material is not damaged. a. Preparing the Material. (1) Place the material (1) on a hard surface with barrel of the snap fastener (2) down. (2) Hold material (1) firmly in place and ream out flanged end of the snap fastener barrel (2) with a drill (3). Separate the fastener halves. (3) Patch the material (1) where the snap fastener was removed IAW paragraph 5-9, except for female snap fasteners on hood straps, then no patch is applied. 5-10

Privacy Statement
Press Release
Contact