TM 10-8415-208-12
3-6.
ENCAPSULATING PROTECTIVE SUIT MAINTENANCE INSTRUCTIONS. (CONT)
NOTE
Align the middle finger of the glove with the seam.
(1)
Insert reinforcement collar (1) about 3 to 4 inches from the top of the cuff of new glove (2).
(2)
Put new glove (2) inside sleeve (3) fingers first.
(3)
Place rubber band (1) on top of sleeve (2).
(4)
Center rubber band (1 ) over reinforcement collar (3).
(5)
Place hose clamp (4) over rubber band (1) and tighten.
(6)
Fold glove cuff back over hose clamp (4).
(7)
Put rubber band (5) over glove assembly.
(8)
Turn sleeve (1) right side out with glove (2) attached.
(9)
Pressure test suit. Refer to paragraph 3-6.4.
3-22
