TM 10-8415-208-12
NOTE
New anti-seize tape is required on the threads of adaptors F101 and F102 before attaching.
(2)
Attach the new component to the tether line assembly where the damaged component was removed.
(3)
Using two wrenches, tighten the connections holding the new component in place.
3-8.
ICE VEST MAINTENANCE INSTRUCTIONS.
This task covers:
a.
Inspection
c.
Service
b.
Replacement
d.
Cleaning
INITIAL SETUP
Tools
Battery Charger (Appendix B, Section III, item 4)
Clamp Pincers (Appendix B, Section III, item 7)
Technical Manual (Appendix B, Section III, item 20)
Pliers (Appendix B, Section III, item 23)
Screwdriver (Appendix B, Section III, item 32)
Wrench (Appendix B, Section III, item 39)
Materials/Parts
Spare/Repair Kit (Appendix B, Section II, item 13)
Battery Pak (Appendix B, Section III, item 3)
Clamp (Appendix B, Section III, item 6)
Coolant Bag (Appendix B, Section III, item 8)
Coat Hanger (Appendix D, Section II, item 9)
Detergent (Appendix D, Section II, item 12)
Electrical Tape (Appendix D, Section II, item 26)
3-8.1
Inspection.
a.
Visually examine the buckles and straps for broken buckles, frayed, ripped or torn straps. If damaged, replace
the ice vest.
b.
Check the slide fastener for proper operation. If the slide fastener does not operate properly, replace the ice
vest.
c.
Inspect the coolant bag and tubing for holes, cuts and punctures. If damaged, refer to paragraph 3-8. 2. 1 to
replace the coolant bag.
d.
Examine all tubing for damage. If damaged, replace the ice vest.
3-33
