TM 10-5410-228-24
(8)
Remove two connectors (11) from hydraulic manifold (3). Remove and discard two O-rings (13)
from two connectors (11).
(9)
Plug open ports on hydraulic manifold (3) and open ends of two tube assemblies (10).
(10) Disconnect two tube assemblies (14) from two connectors (15) on hydraulic manifold (3). Remove
and discard two O-rings (16) from two connectors (15).
(11) Remove two connectors (15) from hydraulic manifold (3). Remove and discard two O-rings (17)
from two connectors (15).
(12) Plug two open ports on hydraulic manifold (3) and open ends of two tube assemblies (14).
(13) Disconnect tube assembly (18) from elbow (19) on hydraulic manifold (3). Remove and discard
O-ring (20) from elbow (19).
(14) Remove elbow (19) from hydraulic manifold (3). Remove and discard O-ring (21) from elbow (19).
(15) Plug open port on hydraulic manifold (3) and open end of tube assembly (18).
(16) Disconnect tube assembly (22) from connector (23) on hydraulic manifold (3). Remove and
discard O-ring (24) from connector (23).
(17) Remove connector (23) from hydraulic manifold (3). Remove and discard O-ring (25) from
connector (23).
(18) Plug open port on hydraulic manifold (3) and open end of tube assembly (22).
(19) Disconnect tube assembly (26) from elbow (27) on hydraulic manifold (3). Remove and discard
O-ring (28) from elbow (26).
(20) Remove elbow (26) from hydraulic manifold (3). Remove and discard O-ring (29) from elbow (27).
(21) Plug open port on hydraulic manifold (3) and open end of tube assembly (26).
(22) Disconnect tube assembly (30) from connector (31) on hydraulic manifold (3). Remove and
discard O-ring (32) from connector (31).
(23) Remove connector (31) from hydraulic manifold (3). Remove and discard O-ring (33) from
connector (31).
(24) Plug open port on hydraulic manifold (3) and open end of tube assembly (30).
The hydraulic manifold is heavy. To prevent injury to personnel, two people are required to
lift the hydraulic manifold.
(25) Remove four bolts (34), four lockwashers (35) and four flat washers (36) securing hydraulic
manifold (3) and mounts (37) to ECU. Remove hydraulic manifold (3) from ECU. Discard four
lockwashers (35).
b. Disassembly (Refer to Figure 3-23)
(1)
Remove four screws (38) securing two mounts (37) to hydraulic manifold (3).
(2)
Remove three plugs (39) from hydraulic manifold (3). Remove and discard three O-rings (40)
from three plugs (39).
NOTE
Plug open ports on hydraulic manifold and open ends of tube assemblies to keep the
hydraulic system free of contaminants.
(3)
Plug three open ports on hydraulic manifold (3).
3-119
