TM 10-5410-228-24
To prevent injury to personnel, always wear eye protection when drilling. This warning
applies to steps 1 through 3.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
This caution applies to steps 1 through 3.
(6)
Drill out three rivets (21) securing mounting angle (22) to guard segment (14).
(7)
Drill out seven rivets (23) securing three mounting angles (18, 19 and 20) to guard wraparound
(24).
(8)
Drill out three rivets (25) securing shim (9) to guard wraparound (24).
NOTE
Soundfoam should only be replaced if damaged. Applies to steps 9 through 12.
(9)
Remove soundfoam (26 and 27) from both sides of guard segment (14).
(10) Remove soundfoam (28) from top surface of top guard (10).
(11) Remove two soundfoams (29) and soundfoam (30) from front side of guard wraparound (24).
(12) Remove soundfoam (31) from back side of guard wraparound (24).
Alcohol solvents are flammable and give off harmful vapors. Use solvents sparingly and only
in well ventilated area. Avoid prolonged breathing of vapors. Keep away from heat, sparks,
open flames.
(13) Clean adhesive residue from guards with rag dampened with alcohol.
c.
Assembly (Refer to Figure 3-7)
NOTE
Reference TM 10-5411-224-14 for general repair procedures using rivets. Applies to steps 6
through 8.
(1)
Secure shim (9) to guard wraparound (24) with three rivets (25).
(2)
Secure three mounting angles (18, 19 and 20) to guard wraparound (24) with seven rivets (23).
(3)
Secure mounting angle (22) to guard segment (14) with three rivets (21).
Alcohol solvents are flammable and give off harmful vapors. Use solvents sparingly and only
in well ventilated area. Avoid prolonged breathing of vapors. Keep away from heat, sparks,
open flames.
NOTE
Soundfoam should only be replaced if damaged.
(4)
Apply new soundfoam to clean, dry surface only. Clean adhesive residue from guard segment
with rag dampened with alcohol. Allow guard segment to dry completely before applying new
soundfoam.
3-41
