TM 10-5410-228-10
E.2
LIGHTWEIGHT MULTIPURPOSE SHELTER (LMS) LOADING.
Roadside:
a. Place one NBC recirculation filter over the wheel well and fasten three straps.
b. Place one medical chest on the wheel well and fasten three straps.
c. Place one litter stand on the sidewall and fasten two straps.
d. Place the inner ambulatory airlock door and inner TALP door behind the retaining bracket. Open
TALP door. Pass the retention strap through the open TALP door and fasten to buckle. Close and
latch TALP door.
Curbside:
e. Place one NBC recirculation filter over the wheel well and fasten three straps.
f. Place one medical chest on the wheel well and fasten three straps.
g. Place one litter stand on the sidewall and fasten two straps.
h. Place suction apparatus next to re-circulation filter and fasten strap.
i. Place two oxygen bottles on floor in rear corner and fasten strap.
j. Place fire extinguisher in bracket next to oxygen bottles and close bracket to hold in place.
k. Fasten the traction splint to the wall using two straps.
Ceiling:
l. Place four litter stands on ceiling and fasten eight straps.
m. Place one TALP rail on either side of litter stands with protruding legs facing towards the center of
the vehicle and fasten in place using two straps for each rail.
E.3
EXPANDED CAPACITY VEHICLE (ECV) COMPARTMENT LOADING.
a. Place large tent pin bag flat on bottom of compartment.
b. Stand small tent pin bag vertically behind environmental control unit drainage reservoir.
c. Place medium tent pin bag on top of large tent pin bag.
d. Place two sledge hammers on top of large tent pin bag.
e. Place fire extinguisher on top of two sledge hammers.
f. Place pioneering kit diagonally on top of all previous components.
g. Close and latch compartment cover.
E.4 FORWARD SURGICAL TEAM (FST) AND LEVEL II MEDICAL TREATMENT FACILITY (MTF)
LOAD PLANS.
The following tables and illustrations identify and illustrate how the Chemical Biological Protective Shelter
(CBPS) System is loaded. Key number (No.) in tables identify where that item is stored in the illustrations.
E-8
Change 1
