TM 5-6350-264-14&P-10NAVELEX EE 181-AA-OMI-110/E121 C-9412T.O. 31S9-2FSS9-1-10Table 5-2. Troubleshooting Procedures - ContinuedTroubleProbable causeCorrective action4. (Cont)g. (Cont)on switch stop. Place large hexnut inside switch mountingbracket; slip bracket over lock.Engage switch shaft in lock.Tighten nut to secure switch.o.If meter indicates 0 ohms, inspect wiresfrom S-3, terminal 3-3 and 3-1 toJ12/P1 pin 33 to J10-4 for looseor broken connections. Resolderany bad connections on P1.p.If meter indicates 0 ohms from S-3, ter-minal 3-4 to J10-4, connect meterleads to J10-5 and power supplyTB2-5.q.If meter indicates 0 ohms, replace PCboard A10.To install new PC board A10,turn board so plastic ejec-tor is toward top. Alignboard with guides at topand bottom of status pro-cessor. Slide boardstraight in until it con-tacts receptacle at back ofprocessor. Then pressfirmly on board until itseats completely in recep-tacle.r.If meter indicates meter indicates morethan 100,000 ohms, inspect wiresfrom S3, terminal 3-4 to J12/P1,pin 28 to J10-5. Resolder any badconnections.s.Reconnect jumper wire between powersupply TB4-1 and 4. Reconnectinterconnecting wire from AA toTB4-3. Remove jumper wire fromTB4-3 and 4.5-80
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
