TM 5-6350-264-14&P-10NAVELEX EE 181-AA-OMI-110/E121 C-9412T.O. 31S9-2FSS9-1-10Table 5-2. Troubleshooting Procedures - ContinuedTroubleProbable causeCorrective action4. (Cont)g. (Cont)(2) To install new PC board A7, turnboard so plastic ejector is to-ward top. Align board withguides at top and bottom ofstatus processor. Slide boardstraight in until it contacts re-ceptacle at back of processor.Then press firmly on board un-til it seats completely in recep-tacle.(3) Turn on switch S1 on power sup-ply. Depress TRANSMITTERRESYNC switch S2. Waitabout 5 minutes for system tostabilize. Turn mode switchto TEST/RESET and then toSECURE.x.If meter indicates more than 10 vdc atJ8-11, remove PC board A10 andreinstall A8.(1) To remove PC board A10, turn offswitch S1 on top of power sup-ply. Place thumb or finger un-der board ejector and lift up un-til board pops out of receptacleat back of status processor.Then grasp PC board and pullstraight out.(2) To reinstall PC board A8, turn boardso plastic ejector is toward top.Align board with guides at topand bottom of status processor.Slide board straight in until itcontacts receptacle at back ofprocessor. Then press firmly onboard until it seats completelyin receptacle.(3) Turn on switch S1 on power sup-ply. Depress TRANSMITTERRESYNC switch S2. Wait about5 minutes for system to stabilize.Turn mode switch to TEST/RESET and then to SECURE.5-82
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
