• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENVIRONMENTAL CONTROL UNIT (ECU). -812530372
Figure 2-56. ECU Covers/Screens Replacement (Sheet 1 of 3)

TM-10-5410-228-24 Chemical Biologiocal Protective Shelter (CBPS) System NSN 5410-01-441-8054 (Green) (EIC:5ZT) NSN 5410-01-482-4633 (Tan) Manual
Page Navigation
  345    346    347    348    349  350  351    352    353    354    355  
TM 10-5410-228-24
(2)
Secure venturi screen frame (13) to ECU (5) with eight screws (10), eight new lockwashers (11)
(Item 18, Appx E) and eight flat washers (12).
2.14.1.5
Condenser Coil Cover Assembly.
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Removal (Refer to Figure 2-56)
(1)
Remove eight screws (16), eight lockwashers (17) and eight flat washers (18) securing condenser
coil cover assembly (19) to ECU (5). Discard eight lockwashers (17).
(2)
Release flush mounted latch (20) and remove condenser coil cover assembly (19) from ECU (5).
b. Installation (Refer to Figure 2-56)
(1)
Secure condenser coil cover assembly (19) to ECU (5) with eight screws (16), eight new
lockwashers (17) (Item 18, Appx E) and eight flat washers (18).
(2)
Secure condenser coil cover assembly (19) to ECU (5) by latching flush mounted latch (20).
2.14.1.6
Side Access Cover Assembly.
a. Removal (Refer to Figure 2-56)
Remove twenty screws (21), twenty lockwashers (22) and twenty flat washers (23) securing side
access cover assembly (24) to ECU (5). Discard twenty lockwashers (22).
b. Installation (Refer to Figure 2-56)
Secure side access cover assembly (24) to ECU (5) with twenty screws (21), twenty new lockwashers
(22) (Item 18, Appx E) and twenty flat washers (23).
2.14.1.7
Prefilter Cover Assembly.
a. Removal (Refer to Figure 2-56)
Release ten quarter turn fasteners (25) securing prefilter cover assembly (26) to ECU (5) and remove
prefilter cover assembly (26).
b. Installation (Refer to Figure 2-56)
Secure prefilter cover assembly (26) to ECU (5) with ten quarter turn fasteners (25).
2.14.1.8
Mist Eliminator.
a. Removal (Refer to Figure 2-56)
Remove six screws (27), six lockwashers (28) and six flat washers (29) securing mist eliminator (30)
with six retaining clips (31) to the ECU (5). Discard six lockwashers (28).
b. Installation (Refer to Figure 2-56)
Secure mist eliminator (30) to ECU (5) with six retaining clips (31), six screws (27), six new
lockwashers (28) (Item 18, Appx E) and six flat washers (29).
2-287






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.