• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Rear Light Box Assembly Replacement.
Figure 2-38. Rear Light Box Assembly Replacement

TM-10-5410-228-24 Chemical Biologiocal Protective Shelter (CBPS) System NSN 5410-01-441-8054 (Green) (EIC:5ZT) NSN 5410-01-482-4633 (Tan) Manual
Page Navigation
  258    259    260    261    262  263  264    265    266    267    268  
TM 10-5410-228-24
2.13.17 Rear Light Box Assembly Replacement Continued.
NOTE
Mounting hardware is supplied with switch (13).
Cable 1A4A10W1 must be removed (per para 2.13.27) before steps 11 and 12 can be
performed.
(11) Remove electrical locknut (25) and electrical bushing (26) securing chase nipple (27) to box (8).
(12) Remove four screws (28), four lockwashers (29) and four flat washers (30) securing box (8) to
ceiling of LMS. Discard four lockwashers (29).
b. Assembly (Refer to Figure 2-38)
(1)
Secure box (8) to ceiling of LMS with four screws (28), four new lockwashers (29) (Item 17, Appx
E) and four flat washers (30).
(2)
Secure chase nipple (27) to box (8) with electrical bushing (26) and electrical locknut (25).
(3)
Secure terminal board assembly (18) to box (8) with two screws (24) and two nuts (23).
(4)
If required, cut any damaged terminal lug(s) (19) from wire and crimp new terminal lug(s) (19)
onto wire.
(5)
Secure terminal lugs (19) to terminal board assembly (18) with two flat washers (22), two new
lockwashers (21) (Item 15, Appx E) and two nuts (20). Remove tags from terminal lugs (19).
(6)
Install cover assembly (17) on terminal board assembly (18).
(7)
Install leads to switch (13). Remove tags from leads.
NOTE
Attaching hardware for switch is supplied with the switch.
(8)
Secure switch (13) to box (8) with locating washer (16), lockwasher (15) and nut (14).
(9)
Secure lamp frame assembly (12) to cover (7) with three flat washers (11), three new
lockwashers (10) (Item 17, Appx E) and three nuts (9).
(10) Secure cover (7) to box (8) with eight screws (4), eight new lockwashers (5) (Item 16, Appx E)
and eight flat washers (6).
(11) Install lamp (1) onto lamp retainer (2).
(12) Secure leads to lamp (1) with two screws (3). Remove tags from leads.
(13) Install lamp (1) and lamp retainer (2) onto lamp frame assembly (12).
2-200






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.