CHAPTER 1 INTRODUCTION - TM-5-6350-264-14P-10

Figure 1-2. Control Unit (Access Door Open)

TM-5-6350-264-14P-10 Alarm Set Control Manual
Page Navigation
1

TM 5-6350-264-14&P-10 NAVELEX EE 181-AA-OMI-11A/E121 C-9412 T.O. 31S9-2FSS9-1-10 CHAPTER 1 INTRODUCTION Section I. GENERAL 1-1. SCOPE. This manual is for your use in operating and maintaining the Alarm Set, Control Unit Model C- 9412/FSS-9(V), under normal operating conditions. The Control Unit (CU) is an integral part of the Joint-Services Interior Intrusion Detection System (J-SIIDS). For information on other major assemblies of J-SIIDS, refer to the applicable manual listed in appendix A.. 1-2. MAINTENANCE FORMS AND RECORDS. Equipment maintenance forms and procedures for their use are contained in DA PAM 738-750, The Army Maintenance Management System (TAMMS). 1-3. ADMINISTRATIVE STORAGE. Instructions for administrative storage are contained in TM 740-90-1. 1-4. DESTRUCTION OF ARMY MATERIEL TO PREVENT ENEMY USE. Instructions for the destruction of Army materiel to prevent enemy use are contained in TM 750-244-3. 1-5. QUALITY ASSURANCE/QUALITY CONTROL. There are no Quality Assurance/Quality Control technical manuals applicable to this equipment. 1-6. REPORTING EQUIPMENT IMPROVEMENT RECOMMENDATIONS (EIR). EIR’s will be prepared on standard Form 368, Quality Deficiency Report. Instructions for preparing EIR’s are provided in DA PAM 738-750. EIR’s should be mailed directly to Commander, U. S. Army Troop Support Comamnd, ATTN: AMSTR- QX, 4300 Goodfellow Blvd. , St. Louis, Missouri 63120- 1798. A reply will be furnished directly to you. Section II. DESCRIPTION AND DATA 1-7. DESCRIPTION. The Control Unit (fig. 1-1 and 1-2) consists of a steel enclosure, a power supply, a battery for emergency operation, a status processor, associated controls, and input/output terminal boards. The enclosure also contains mounting provisions for the Data Transmitter T-1257/FSS-9(V) (not part of the Control Unit). The Control Unit is the central control element of J-SIIDS. A tamper alarm switch (TAS) automatically initiates an alarm when the access door is opened. 1-8. TABULATED DATA. a. Identification Data. There are three identification plates on the Control Unit as follows: One located inside the access door (fig. 1-3, view a); one located on top of the power supply (fig. 1-3, view b); one located on the bottom of the status processor (fig. 1-3, view c). b. Equipment Characteristics. Weight (Control Unit less battery and Data Transmitter .............. 38 pounds (17.24 kg) Dimensions (overall) Height............................... 22.500 inches (57.5 cm) Width................................ 8.250 inches (21.0 cm) Depth ............................... 14.625 inches (37.0 cm) Change 1 1-1

Privacy Statement
Press Release
Contact