TM 5-3740-218-13&P
NOTE
Square cut ring and thrust plate may or may not remain with cover.
Take special note of wear pattern on thrust plate and wear plate. Note that long
journal of drive gear is toward drive end of motor.
(7)
If square cut ring (8) and thrust plate (9) remain with body (1), remove square cut ring (8) and lift out thrust
plate (9). Discard square cut ring.
(8)
Lift out drive gear shaft (5), drive gear (10), wear plate (11), and pressure loading seal (12). Discard
pressure loading seal.
CAUTION
Remove shaft seal carefully. Do not damage shaft seal bore or seal leakage will
result.
(9)
Remove ball bearings (13).
(10)
Invert motor body with shaft seal (14) up. Remove retainer (15). Remove shaft seal (14) by prying seal out
with large screwdriver. Discard shaft seal.
5-43
