TM 5-3740-214-14
Table 5-3. Direct and General Support Maintenance Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE LACKS POWER (Continued)
c.
Connect the negative (-) meter lead to the side of the condenser and the positive (+) meter lead to the
wire terminal.
(1)
If the meter reads below infinity, the condenser is ok. Go to Step 4.
(2)
If the meter reads at infinity and remains there, replace the condenser. Go to Step 3e.
d.
Tap the condenser lightly. If the meter fluctuates, there are loose connections inside the condenser.
(1)
If there are no loose connections, go to Step 4.
(2)
If there are loose connections, replace the condenser and go to Step 3e.
e.
Start the engine.
(1)
If the engine starts, the problem is solved.
(2)
If the engine does not start, go to Step 4.
Step 4.
Check the ignition switch.
a.
Turn the ignition switch ON.
b.
Turn the cab control panel light ON.
(1)
If the light comes on, the ignition switch is ok. Go to Step 5.
(2)
If the light does not come on, go to Step 4c.
Figure 5-124. Engine Control Panel Test
5-115
