SECTION I
INTRODUCTION
maintenance category requiring such repair parts will
1. Scope
attempt to obtain same through cannibalization.
This manual lists repair parts, special tools, test and
Where such repair parts are not obtainable through
support equipment required for the performance of
cannibalization, requirements will be requisitioned,
direct support, general support, and depot maintenance
with accompanying justification, through normal
of the conversion, storage and charging unit.
supply channels.
2. General
G
Major assemblies that are procured with PEMA funds
This Repair Parts and Special Tools List is divided into
for initial issue only as exchange assemblies of DSU
the following sections:
and GSU level. These assemblies will not be
a. Repair Parts-Section II. A list of repair parts
stocked above DS and GS level or returned to depot
authorized for the performance of maintenance at the
supply level.
(2) Maintenance code indicates the lowest
direct support, general support, and depot level in figure
category of maintenance authorized to install the listed
and item number sequence.
item. The maintenance level codes are:
b. Special Test and Support Equipment -Section III.
Code
Explanation
(Not Applicable).
O............ Organizational maintenance
c. Federal Stock Number and Reference Number
F ............ Direct support maintenance
Index-Section IV. A list of Federal stock numbers in
H ............ General support maintenance
ascending numerical sequence followed by a list of
D ............ Depot maintenance
reference numbers in ascending alpha-numeric
(3) Recoverability code indicates whether
sequence, cross-referenced to the illustration figure
unserviceable items should be returned for recovery or
number and item number.
salvage.
Items not coded are expendable.
Recoverability codes are:
Note. Items not illustrated are cross-referenced to
Code Explanation
group number.
R
Applied
to
repair
parts
(assemblies
and
3. Explanation of Columns
components)which are considered economically
The following provides an explanation of columns in the
repairable at direct and general sup port
tabular lists in sections II and III:
maintenance levels.
When the maintenance
a. Source, Maintenance, and Recoverability Codes
capability to repair these items does not exist, they
(SMR).
are normally disposed of at the GS level. When
(1) Source code indicates the selection status and
supply conditions dictate, some of these repair parts
source for the listed item. Source codes used are:
may be listed for automatic return to supply for depot
Code
Explanation
level repair as set forth in AR 710-50. When so
P
Repair parts which are stocked in or supplied from
listed, they will be replaced by supply on an
the GSA/DSA or Army supply system and author
exchange basis.
ized for use at indicated maintenance categories.
S
Repair parts and assemblies which are economically
repairable at DSU and GSU activities and which are
P2
Repair parts which are procured and stocked for
normally furnished by supply on an exchange basis.
insurance purposes because the combat or military
When items are determined by a GSU to be
essentiality of the end item dictates that a minimum
uneconomically repairable, they will be evacuated to
quantity be available in the supply system.
a depot for evaluation and analysis before final
M
Repair parts which are not procured or stocked, but
disposition.
are to be manufactured in indicated maintenance
T
High dollar value recoverable repair parts which are
levels. A Assemblies which are not procured or
subject to special handling and are issued on an
stocked as such, but are made up of two or more
exchange basis. Such repair parts are normally
units. Such component units carry individual stock
repaired or overhauled at depot maintenance
numbers and descriptions, are procured and stocked
activities.
separately and can be assembled to form the
U
Repair parts specifically selected for salvage by
required assembly at indicated maintenance
reclamation units because of precious metal content,
categories. X Parts and assemblies which are not
critical materials, or high dollar value reusable
procured or stocked and the mortality of which
casings or castings.
normally is below that of the end item or component.
The failure of such part or assembly should result in
b. Federal Stock Number. This column indicates
retirement of the end item from the supply system
the Federal stock number assigned to the item and will
Code Explanation
be used for requisitioning purposes.
X1
Repair parts which are not procured or stocked. The
requirement for such items will be filled by use of the
c. Description. This column indicates the Federal
next higher assembly or component.
item name and any additional description of
X2
Repair parts which are not stocked. The indicated
ii
