TM 3-6665-316-12
PREPARATION
FOR
MOVEMENT
(continued)
2-7.
CAUTION
M43A1
Interface
Cable
must
be
stowed
with
pins
up.
17.
Stow M43A1 Interface
Cable
(13)
and
receiver
(14)
in
compartments
in
transit case.
18.
Repeat steps in Paragraph
2-7b
and
Steps
1
thru
17
in
Paragraph
2-7c
for each receiver.
19.
Lower
transit
case
top
and
secure
five
latches
(15).
Position case-bottom assembly so that USUAL RESERVICING INSTRUCTIONS
20.
plate is toward you.
Position case-top assembly above case-bottom
assembly so that the words 24 VDC INPUT and AIR FILTER are toward
you .
21.
Lower case-top assembly
until
its
bottom
surface
contacts
top
surface
of case-bottom assembly.
22.
Engage four latches on case-bottom assembly with catches on
case-top
Push down on latch-locking tabs to lock latches.
assembly.
2-8.
OPERATING INSTRUCTIONS ON DECALS AND INSTRUCTIONS PLATES
See
Chapter
1,
Section
II,
Paragraph
l-8b,
Item
5,
of
this
manual.
Section
IV.
O P E R A T I O N UNDER UNUSUAL CONDITIONS
The Simulator will always be used with the M43A1 Detector. No special procedures
are required to operate the Simulator under unusual weather or environmental condi-
However, it should be noted that the Simulator highest operating temperature
tions.
(1OOF) is lower than the highest operating temperature for M43Al Detector (120F).
Also, the lowest operating temperature for the Simulator (20F) is higher than the
lowest operating temperature for M43A1 Detector (-40F).
2-24