• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HAND CONTROL ASSEMBLY REPAIR - Continued
HAND CONTROL ASSEMBLY REPAIR - Continued

Operator Manual Pesticide Dispersal Unit, Multicapability, Helicopter Slung
Page Navigation
  263    264    265    266    267  268  269    270    271    272    273  
img
.
TM 5-3740-218-13&P
HAND CONTROL ASSEMBLY REPAIR (CONT)
C.
ASSEMBLY
(1)
Insert pushbutton switch (1) through proper opening in hand control assembly (2) and secure by hand-
threading nut (3) with washer (4).
(2)
Hand-thread three nuts (5) and three washers (6) to secure three toggle switches (7).
(3)
Secure three LED indicators (8) with three plastic nuts (9). Tighten all nuts.
(4)
Place 1/2-in. heat shrink tubing (item 63, Appendix E) on each wire and apply flux to solder connections
before soldering.
(5)
Solder wires to connector (10).
(6)
Slide heat shrink tubing over each solder connection and apply heat with heat gun.
(7)
Secure connector (10) by installing four screws (11).
(8)
Solder wires to toggle switches (7 and pushbutton switch (1).
)
(9)
Slide heat shrink tubing over each solder connection and apply heat with heat gun.
(10)
Solder wires to LED indicators (8).
(11)
Slide heat shrink tubing over each solder connection and apply heat with heat gun.
(12)
Secure hand control assembly cover (12) by installing two screws (13).
(13)
Install hand control assembly cover (12) with gasket making sure three toggle switches (7) and three LED
indicators (8) are inserted through proper openings.
5-36






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.