2-45. SKID ASSEMBLY (CONT).
Pipe-to-tube elbow (18)
Wrap antiseizing tape around external pipe thread of pipe-to-tube
Pipe bushing (19)
elbow (18), pipe bushing (19), pipe-to-tube tee (20), and pipe bushing (21)
Pipe-to-tube tee (20)
Pipe bushing (21)
Screw pipe-to-tube elbow (18) into pipe bushing (19) and then install into
bottom of fuel pump assembly (13). Position so open end of pipe- to-tube
elbow (18) is pointing toward the fluid vacuum filter side of skid base (2).
Flat washers (22 and 23)
Screw pipe-to-tube tee (20) and pipe bushing (21) together and install flat
washer (22) on end of pipe bushing (21). Insert end of pipe bushing (21)
Quick disconnect coupling
through hole of skid base (2) and then add flat washer (23) and quick
disconnect coupling half (24).