2-11. ACCESS COVER (CONT).
Replace authorized unserviceable parts. When gaskets are loose but not
brittle or damaged, rebond to cover panel with adhesive. Fabricate gas-
kets (fig D-1 2) as required. Fabricate gaskets (fig D-10) as required.
Repair cover paneI by straightening dents, removing rust, and repainting
lettering with black polyurethane coating and small paint brush. Use
green polyurethane coating to paint the panel. Refer to TM 43-0139.
Repaint REMOVE BEFORE OPERATING in 1 1/2 inch high lettering with
black polyurethane coating.
Bond gaskets (1) to back side of cover panel (2) with adhesive. Cut holes
Cover panel (2)
in gaskets (1) at assembly to fit.
Bond gaskets (3) to back side of cover panel (2) with adhesive. Cut holes
in gaskets (3) at assembly to fit.
Use camloc fastener tool and camloc fastener pliers to replace turnlock
stud assemblies (4), turnlock fastener eyelets (5), and retaining rings (6).
Retaining rings (6)