• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Disassembly -812530560
Installation -812530562

TM-10-5410-228-24 Chemical Biologiocal Protective Shelter (CBPS) System NSN 5410-01-441-8054 (Green) (EIC:5ZT) NSN 5410-01-482-4633 (Tan) Manual
Page Navigation
  531    532    533    534    535  536  537    538    539    540    541  
TM 10-5410-228-24
(2)
Remove twenty-two screws (32) securing boot mounting frame (33) and inlet air boot (34) to
ECU (14). Pull boot free of sealant.
(3)
Remove four gaskets (35) from LMS. Discard four gaskets (35).
(4)
Remove gasket (36) from mounting plate (26). Discard gasket (36).
(5)
Remove two gaskets (37) from angle mounts (15 and 16). Discard gaskets (37).
(6)
Remove two gaskets (38) from sides of ECU. Discard gaskets (38).
Alcohol solvents are flammable and give off harmful vapors. Use solvents sparingly and only
in well ventilated area. Avoid prolonged breathing of vapors. Keep away from heat, sparks,
open flames.
(7)
Remove adhesive residue from areas that gaskets were installed using rag dampened with
isopropyl alcohol.
c.
Assembly (Refer to Figure 3-26)
Adhesives and cleaners are flammable and give off harmful vapors. Use adhesive and cleaner
sparingly and only in well ventilated area. Avoid prolonged breathing of vapors. Keep away
from heat, sparks, open flames. Wear gloves when handling adhesive and cleaner.
(1)
Install two new gaskets (38) (Figure D-30, Appx D) to sides of ECU with adhesive (Item 5, Appx
C). Cut gaskets to length.
(2)
Install two new gaskets (37) (Figure D-30, Appx D) to angle mounts (15 and 16) with adhesive
(Item 5, Appx C). Cut gaskets to length.
(3)
Install new gasket (36) (Figure D-30, Appx D) to mounting plate (26) with adhesive (Item 5,
Appx C).
(4)
Install four new gaskets (35) (Figure D-9, Appx D) onto LMS with adhesive (Item 5, Appx C).
(5)
Secure boot mounting frame (33) and inlet air boot (34) to ECU (14) with twenty-two screws
(32). Ensure that inlet air boot (34) flange is laying flat between boot mounting frame (33) and
ECU (14). Torque screws (32) to 50 in.-lb.
(6)
Secure boot mounting frame (30) and outlet air boot (31) to ECU (14) with twelve screws (27),
twelve new lockwashers (28) (Item 18, Appx E) and twelve flat washers (29). Ensure outlet air
boot (31) flange is laying flat between boot mounting frame (30) and ECU (14). Torque screws
(27) to 50 in.-lb.
3-137






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.