• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-6. R22 Refrigerant System Servicing (Sheet 10 of 10)
Assembly -812530465

TM-10-5410-228-24 Chemical Biologiocal Protective Shelter (CBPS) System NSN 5410-01-441-8054 (Green) (EIC:5ZT) NSN 5410-01-482-4633 (Tan) Manual
Page Navigation
  434    435    436    437    438  439  440    441    442    443    444  
TM 10-5410-228-24
3.9.2
Sound Guard Replacement.
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
Power shut off. Power panel and rear control panel
Repair (Item 38, Appendix B)
tagged.
Drill, Electric (Item 6, Appendix B)
LMS guard removed (see para 2.13.15).
Drill Set (Item 5, Appendix B)
ABS inflation air hose disconnected
Gloves (Item 16, Appendix B)
(see para 2.13.7).
Goggles (Item 17, Appendix B)
References:
Riveter, Blind, Hand (Item 34, Appendix B)
TM 10-5411-224-14
Collar Set, Drill Stop (Item 2, Appendix B)
Materials/Parts: (Cont.)
Materials/Parts:
Isopropyl Alcohol (Item 12, Appendix C)
Thirteen Blind Rivets (Item 78, Appendix E)
Rags, Wiping (Item 39, Appendix C)
Seventeen Lockwashers (Item 17, Appendix E)
NOTE
Removal of the strainer per para 3.9.5 will allow better access to the sound guard attaching
hardware.
a. Removal (Refer to Figure 3-7)
Remove six screws (1), six lockwashers (2) and six flat washers (3) securing sound guard (4) to inside
of ECU enclosure (5). Discard six lockwashers (2).
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
b. Disassembly (Refer to Figure 3-7)
(1)  Remove three screws (6), three lockwashers (7) and three flat washers (8) securing shim (9) to
guard top (10). Discard three lockwashers (7).
(2)
Remove two screws (11), two lockwashers (12) and two flat washers (13) securing guard top (10)
to guard segment (14). Discard two lockwashers (12).
(3)
Remove six screws (15), six lockwashers (16) and six flat washers (17) securing guard segment
(14) to three mounting angles (18, 19, and 20). Discard six lockwashers (16).
(4)
Remove guard top (10) from shim (9) and guard segment (14).
(5)
Remove guard segment (14) from three mounting angles (18, 19 and 20).
3-40






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.