• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Drain/Fill Hydraulic System.
Figure 2-58. Drain/Fill Hydraulic System

TM-10-5410-228-24 Chemical Biologiocal Protective Shelter (CBPS) System NSN 5410-01-441-8054 (Green) (EIC:5ZT) NSN 5410-01-482-4633 (Tan) Manual
Page Navigation
  351    352    353    354    355  356  357    358    359    360    361  
TM 10-5410-228-24
b. Fill (Refer to Figure 2-58)
Do not mix or substitute any other hydraulic fluid with MIL-H-5606.
NOTE
Install ECU work platform (reference TM 10-5410-228-10).
When filling the hydraulic reservoir, do not fill past the appropriate mark: COLD when
system has not been running or has been running for less than 20 minutes; HOT when
system has been running for more than 20 minutes. If hydraulic fluid is past the COLD mark
when system has not been running, hydraulic fluid can overflow through the hydraulic
reservoir filler cap.
When required, add just enough fluid to reach the mid-point on the gage. Start the system
and let it reach operating temperature, then shut it off and check again. At 0_F and above,
fluid can be checked before starting.
(1)  Unscrew and remove filler cap (8) from hydraulic reservoir (9).
(2)
Remove filter.
(3)
Place funnel with flex spout into filler opening on hydraulic reservoir (9).
(4)
Fill hydraulic reservoir (9) with hydraulic fluid.
(5)
Inspect fluid level on gage (10) and add hydraulic fluid as necessary to bring level to above mid-
point on gage.
(6)
Remove funnel with flex spout from filler opening on hydraulic reservoir (9).
(7)
Install filter.
(8)
Install cap (8) onto hydraulic reservoir (9).
Change 1
2-293






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.