• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 2-29. Electrical Raceway Replacement (Sheet 3 of 3)
Figure 2-30. Door Assembly Replacement

TM-10-5410-228-24 Chemical Biologiocal Protective Shelter (CBPS) System NSN 5410-01-441-8054 (Green) (EIC:5ZT) NSN 5410-01-482-4633 (Tan) Manual
Page Navigation
  242    243    244    245    246  247  248    249    250    251    252  
TM 10-5410-228-24
2.13.9 Door Assembly Replacement.
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
Strap removed (see para 2.13.5).
Caulking Tool, Hand (Item 18, Appendix B)
Drill, Electric (Item 6, Appendix B)
References:
Drill Set (Item 5, Appendix B)
TM 10-5411-224-14
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
Collar Set, Drill Stop (Item 2, Appendix B)
Materials/Parts:
Materials/Parts: (Cont.)
Rubber Gloves (Item 25, Appendix C)
Four Self-locking Nuts (Item 46, Appendix E)
Sealer (Item 50, Appendix C)
Eight Blind Rivets (Item 78, Appendix E)
Four Lockwashers (Item 18, Appendix E)
Four Blind Rivets (Item 81, Appendix E)
Adhesive (Item 4, Appendix C)
Isopropyl Alcohol (Item 12, Appendix C)
Wiping Rags (Item 39, Appendix C)
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Removal (Refer to Figure 2-30)
Remove four screws (1), four flat washers (2) and four self-locking nuts (3) securing door (4) and six
shims (5) to LMS. Discard four self-locking nuts (3).
b. Disassembly (Refer to Figure 2-30)
(1)  Remove four screws (6), four flat washers (7), four lockwashers (8) and four nuts (9) securing
two keepers (10), two keeper shims (11) and two keeper shims (12) to two door keeper brackets
(13). Discard four lockwasher (8).
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
(2)  Drill out eight rivets (14) and four rivets (15) securing two door keeper brackets (13) and two
shims (16) to LMS.
(3)  Remove gasket (17) from LMS.
c.
Assembly (Refer to Figure 2-30)
2-184
Change 1






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.