• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 2-28. Air Beam Inflation Replacement
Electrical Raceway Replacement Continued.

TM-10-5410-228-24 Chemical Biologiocal Protective Shelter (CBPS) System NSN 5410-01-441-8054 (Green) (EIC:5ZT) NSN 5410-01-482-4633 (Tan) Manual
Page Navigation
  237    238    239    240    241  242  243    244    245    246    247  
TM 10-5410-228-24
2.13.8 Electrical Raceway Replacement.
This task covers:
a. Disassembly
b. Assembly
INITIAL SETUP
Tools/Test Equipment:
Equipment Conditions:
Shop Equipment, Automotive Maintenance and
ECV parking brake set.
Repair (Item 38, Appendix B)
Drill, Electric (Item 6, Appendix B)
References:
TM 10-5411-224-14
Drill Set (Item 5, Appendix B)
Goggles (Item 17, Appendix B)
Riveter, Blind, Hand (Item 34, Appendix B)
Collar Set, Drill Stop (Item 2, Appendix B)
Materials/Parts: (Cont.)
Materials/Parts:
Two Lockwashers (Item 17, Appendix E)
Twenty-two Blind Rivets (Item 77, Appendix E)
Anitseize Compound (Item 13, Appendix C)
Eighteen Blind Rivets (Item 78, Appendix E)
NOTE
Remove/disassemble only to the extent necessary to remove or replace defective
assemblies/components. Use standard maintenance shop practices/procedures.
a. Disassembly (Refer to Figure 2-29)
(1)
Remove nine cover clips (1) from electrical raceway.
(2)
Remove cover assembly (2), raceway covers (3, 4, 5 and 6), rear raceway cover (7) and three
elbow covers (8).
(3)
Remove eleven 3300 wire retainers (9) and three 2200 wire retainers (10).
(4)
Remove cable assemblies (see para 2.13.27).
To prevent injury to personnel, always wear eye protection when drilling.
Make sure drill bit has a drill stop to prevent the drill bit from exceeding a depth of one inch.
(5)
Drill out five rivets (11) securing storage box raceway (12) to LMS.
(6)
Remove three elbows (13).
(7)
Drill out five rivets (14) securing top left front raceway (15) to LMS.
(8)
Remove two screws (16) securing coupler (17) to internal elbow (18) and driver side front
raceway (19). Remove internal elbow (18).
(9)
Drill out seven rivets (20) and eight rivets (21) securing driver side front raceway (19) to LMS.
(10) Remove modified elbow (25).
(11) Drill out two rivets (26) securing rack raceway (27) to LMS.
(12) Drill out seven rivets (28) securing rear raceway (29) to LMS.
(13) Remove two screws (32), two lockwashers (33) and two flat washers (34) securing two pipe
straps (35) and two pipe spacers (36) to LMS. Discard two lockwashers (33).
2-179






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.